This article takes you through the process of setting up a partial arm setting through the hub. It's a little more complex than the process through the mobile app so for basic settings, you may want to use the mobile app for partial arm instead.
Plan Features
Partial arming is only available on the Plus or Complete plans. This feature is not available to subscribers on our Lite or Starter subscriptions
Partially Arm Selected Rooms
To create a partial arm setting through the hub, follow these instructions:
- Tap the hub screen to "wake" it up
- Enter your user PIN
- Tap the Cancel button if you are prompted to arm the alarm
- Tap the Part Arm option
- Tap the Part Set option
- Your rooms will then be displayed in a list. Tap the checkbox next to the room name you wish to protect, you can select more than one. All the sensors assigned to that room will be included.
- Tap the Arm Selected button
- The hub will check the sensors and the countdown timer will begin
- Only the sensors you selected will now be armed
Omit Selected Sensors
You can also arm the system but only arm selected sensors as follows:
- Tap the hub screen to "wake" it up
- Enter your user PIN
- Tap the Cancel button if you are prompted to arm the alarm
- Tap the Part Arm option
- Tap the Omit Device option
- Your sensors will then be shown in a list. Tap the checkbox next to the sensor name you wish to omit, you can select more than one
- Tap the Omit Selected option
- Tap the Red Cross until you get back to the hub main screen
- Enter your PIN code
- Tap the Continue button to arm the system
- The system will then arm with only the sensors you have not disabled. This will reset once you return and disarm the alarm
Disable Selected Sensors
If you wish to disable selected sensors permanently (or until you change your mind) from the arming process, follow these instructions:
- Tap the hub screen to "wake" it up
- Enter your user PIN
- Tap the Cancel button if you are prompted to arm the alarm
- Tap the Part Arm option
- Tao the Inhibit Device option
- Your sensors will then be shown in a list. Tap the checkbox next to the sensor name to inhibit, you can select more than one
- Tap the Inhibit Selected option
- Tap the Red Cross until you get back to the hub main screen
- Enter your PIN code
- Tap the Continue button to arm the system
- The system will then arm with the sensors you omitted disabled until you re-enable them
Sensors will remain disabled until you follow the process above and re-enable them.